Poynting 2×2 MIMO PUCK-5 5G/LTE Vehicle Antenna for Cellular Routers & Hotspots 617–6000 MHz

Features of the Poynting PUCK-5 2×2 MIMO antenna

• 3.9″ d × 1.4″ h (99.3 × 36 mm) omnidirectional MIMO vehicle, marine, and IoT/M2M antenna.
• Receives 4G/LTE and 5G cellular signal from 617 to 4200 MHz; broadcasts 2.4 & 5 GHz WiFi signal.
• Five 6.6′ (2 m) SMA-male RTK031 coax cables connect to cellular (×2), WiFi (×2), and GPS (×1) ports on a cellular router, modem, or hotspot. The cables are enclosed in a braided protection sleeve.
• Mounts on or above the roof of an RV, motorhome, trailer, van, truck, or other vehicle.
• Six mounting options (mounting accessories included, except where noted):
  1. Magnetic base attaches to a steel vehicle roof or other ferrous surface. (Includes a side-exit channel for the coax cable.)
  2. Surface mount attaches securely to non-magnetic roofs and surfaces with a double-sided 3M® foam adhesive pad.*
  3. Spigot mount attaches through a 0.8″ (20 mm) hole with 1.2″ (30 mm) or 2.75″ (70 mm) two-piece threaded spigot posts and nut.
  4. Pipe mount bracket attaches to a vertical or horizontal pole. (Requires a cable tie or hose clamp, purchased separately.)
  5. Wall mount bracket attaches to a drillable vertical surface with screws of appropriate length (purchased separately).
  6. Panel mount attaches through a thin surface with M4×10 mm bolts (included) or through a thicker drillable surface with longer M4 bolts (purchased separately).*
• The rugged PC+ABS enclosure is IK10 impact-rated and IP 69K-rated for protection against water immersion and dust. It’s also rated for wind conditions up to 135 mph (220 kph), depending on the selected mounting option.
• Ground plane-independent.
• 50-ohm impedance.
• 2-year warranty.

* Requires a drilled entry point below the center the antenna to run the coax cable bundle.