The Marine Cel-Fi GO G32 cell phone signal booster improves cellular reception for boats and vessels that are moored and are underway. Stay connected on lakes, rivers, and coastal waters. Experience faster 5G/4G data and fewer dropped calls, undelivered texts, and missed email messages.
* 100 dB stationary mode is available only when the Cel-Fi GO G32 booster is powered by the 120V AC power supply.
When having a usable cell phone signal in your boat isn’t a luxury, it’s a critical necessity.
The Poynting OMNI-493 is the right choice if you need a shorter antenna or if you want the best reception for high-frequency cellular bands that have faster data rates. It has 6 dBi of gain on low-band cellular frequencies (617–960 MHz) and 9 dBi of gain on higher-band frequencies (1710–2700 MHz). Higher frequencies have a shorter range but offer faster data rates, so the Poynting OMNI-493 is the better option if faster data is more important for you than receiving signal at longer distances from cell towers.
The Poynting antenna attaches to a standard 1″ × 14 thread marine mount (with a ¾″ hole beneath the mount to run the coax cable) or to poles or posts 1½″ to 2″ in diameter. It’s also shorter than the RFI antenna, which may make it the better choice if you have minimum-clearance concerns for your vessel.
The Poynting OMNI-493 comes with your choice of 10′, 20′, 30′, 50′ or 75′ of low-loss TS-400 coax cable.
The RFI CDQ7199 is the right choice if you want the best reception for low-frequency cellular bands that have a longer range. It has 8.5 dBi of gain on low-band cellular frequencies (617–960 MHz) and 4.5 to 5.5 dBi of gain on higher-band frequencies (1710–2700 MHz). Lower frequencies offer slower data rates but have a longer range, so the RFI CDQ7199 is the better option if receiving signal at longer distances from cell towers is more important for you than having faster data speeds.
The RFI antenna attaches to a standard 1″ × 14 thread marine mount. It includes RFI’s Q‑Fit® threaded quick-release connector for fast, easy takedown and setup for low minimum-clearance passages—the antenna attaches and detaches from its base in seconds.
The RFI CDQ7199 includes 16.4′ (5 m) of attached RG58 coax cable. You may extend that with a 10′, 20′, 30′, or 50′ run of low-loss TS-400 coax cable.
With the Cel-Fi WAVE app for smartphones you can check your Cel-Fi GO G32 booster’s status and change its settings:
You can install the Marine Cel-Fi GO G32 yourself. It does not require professional help, although you can hire a marine electronics specialist to do the job for you.
Click here to download the two-page PDF installation guide for instructions and tips on setting up this system in your boat.
This is a complete kit, with everything you need to start getting the best signal in your vessel:
The Poynting OMNI-493 antenna kit includes:
The RFI CDQ7199 antenna kit includes:
This Cel-Fi GO G32 Smart Signal Booster system works with Verizon 5G/4G LTE cellular bands and AT&T, T‑Mobile, UScellular, and GCI Alaska 5G/4G LTE/3G cellular bands. It does not work with other cellular networks, and it does not boost Verizon 3G.
The Cel-Fi GO G32 operates on two cellular bands simultaneously from a single carrier. It will support only one carrier at a time.
Not sure which bands your phone uses? Contact us—our technical support reps will be happy to help you!
The Top Signal EDGE panel antenna has four installation configurations:
The back of the panel includes a channel for the pigtail cable so it will mount flush against walls and ceilings.
Command™ brand is a trademark of 3M.
For information on federal rules governing the use of consumer cell signal boosters, please see our FCC notice page.
Warning This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information go to www.P65Warnings.ca.gov
For warranty information on this product, please see our Cel-Fi warranty information page.
Questions & Answers