Product Description
Features of the Wilson 50-ohm lightning surge protector
- N-female connectors on both ends.
- Built-in grounding screw. (Ground wire not included.)
- Jumper cable terminated with N-male connectors required to attach to booster. (Available as an optional add-on, above.)
- DC–5800 MHz frequency range.
- 50 ohm impedance.
- Attenuates < −0.2 dB.
How the Wilson 50-ohm lightning surge protector is used
- When properly installed and attached to a ground wire, this gas-discharge surge protector interrupts the spike in power from a nearby lightning strike, directing it to ground instead of to a cell signal booster. (See our instructions for installing a lightning surge protector.)
- Gas discharge element is replaceable.
- For in-building use with 50-ohm cell signal booster systems and coax cable terminated with N-male connectors.
Wilson 50-ohm lightning surge protector contents
50-ohm lightning surge protector 850050
Optional add-on
2′ TS-400 coax jumper cable TS340002
Please note
- Requires a ground wire and ground stake (not included).
- This product will not protect against a direct lightning strike to an antenna. If you are concerned about lightning strikes, we recommend installing a lightning rod suitable to your building.
Product Specifications
Connector Type:
N-female
Cable Type:
400 coax & plenum coax
Frequency Range:
DC–5800 MHz (5.8 GHz)
Impedance:
50 Ω
Gain/Loss:
< −0.2 dB
Warranty Information
For warranty information on this product, please see our Wilson Electronics warranty information page.
Warning Cancer and reproductive harm. www.P65Warnings.ca.gov
