Wilson 400 N-Male Crimp Connector 971109

How the N‑male crimp connector is used

• Application requires soldering; for a non-solder connector, see the Top Signal 400 N‑Male EZ‑Crimp Connector TS452040.
• Application instructions: (The video below has a walk-through of these steps.)

1. Prepare unterminated cable end with CST400 coax cable prep tool (sold separately).
2. Slip polyethylene sleeve (not included) and crimp tube over cable.
3. If necessary, cut center conductor to appropriate length to match center pin.
4. Slip center pin over center conductor and solder pin in place through hole at center pin’s base.
5. Attach connector to cable end.
6. Pull crimp tube up to connector base, crimp in position with DL-801K ratchet crimping tool (sold separately).
7. If using a polyethylene sleeve, fit sleeve around crimp tube and apply heat gun to shrink sleeve in position.